BKQNH - ROL ANTI-CORROSIVE METAL PRIMER, 073217

  • MSDS: BKQNH
  • Manufacturer: M A BRUDER AND SONS INC
  • Product Name: ROL ANTI-CORROSIVE METAL PRIMER, 073217
  • National Stock Number: 8010-00N016134
Product Identification

Product ID:ROL ANTI-CORROSIVE METAL PRIMER, 073217
MSDS Date:05/11/1988
FSC:8010
NIIN:00N016134
MSDS Number: BKQNH

Responsible Party
M. A. BRUDER & SONS INC.
600 REED ROAD
BROOMALL, PA 19008
US

Emergency Phone: 215-353-5100 215-853-2051

Info Phone: 215-353-5100

Cage: HO854

Contractor
M. A. BRUDER & SONS INC.
600 BROOMALL, PA 19008 US

Telephone: 215-353-5100

Cage: HO854

Ingredients

ALKYD RESIN

CAS: 68072-13-9


(FIRE EXPLO HAZ) APPARENT. OBTAIN MED ATTN. SUPP

RTECS: 9999999ZZ


FUMES. RAGS/WASTE CONT OIL BASED PAINT/VARNISH

RTECS: 9999999ZZ


OXIDIZE & MAY IGNITE SPONTANEOUSLY & SHOULD KEEP

RTECS: 9999999ZZ


TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 3-5%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293


(MG. SILICATE (TALC)) TALC, CONTAINING NO ASBESTOS FIBERS

CAS: 15702-53-1

Fraction By Weight: 14-18%

OSHA PEL 20 MPPCF

ACGIH TLV: 2 MG/M3 R DUST


K-AL SILICATES

CAS: 1327-44-2

Fraction By Weight: 5-9%

OSHA PEL 20 MPPCF (MFR)

ACGIH TLV: 10 MG/M3 (MFR)


(BARIUM METABORATE MONOHYDRATE) BARIUM METABORATE

CAS: 13701-59-2

RTECS: CQ9570000

Fraction By Weight: 7-11%

OSHA PEL 15 MG/M3

ACGIH TLV: 10 MG/M3 (MFR)


LOW ODOR PETROLEUM SOLVENT

CAS: 64742-48-9

Fraction By Weight: 3-5%

OSHA PEL 500 PPM (MFR)

ACGIH TLV: 100 PPM (MFR)


STODDARD SOLVENT

CAS: 8052-41-3

RTECS: WJ8925000

Fraction By Weight: 31-37%

OSHA PEL 500 PPM

ACGIH TLV: 100 PPM; 9293

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHAL: CAN CAUSE ANESTH RXN. POSS
ACUTE NRVS SYS DEPRESS/IRRIT OF RESP TRACT CHARACT BY FOLLOWING
STEPS: HDCH, DIZZ, STAG GAIT, CONFUSN, UNCON & COMA. NOTE: INT
MISUES BY DELIB CONC & INHAL CONTENTS M AY BE HARMFUL/FATAL. RPTS
HAVE ASSOC RPTD & PRLNG OCCUPATIONAL OVEREXPOS TO SOLV
W/PERMANENT (SEE EFTS OF OVEREXPOS).
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: BRAIN & NRVS SYS DAMAGE. ACUTE
SKIN/EYE CONTACT: PRIMARY IRRIT. CHRONIC INHAL & SKIN/EYE CONTACT:
EFTS OF EXCESS, CHRONIC EXPOS HAVEN'T BEEN FULLY INVEST. RPTD
HNDLG/USE MAY PRESENT ADDTNL H AZ. EXERCISE DUE CARE.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid

First Aid:VAPORS: REMOVE FROM EXPOS. RESTORE BREATHING. KEEP WARM &
QUIET. CALL M.D. EYES: FLUSH IMMED W/LARGE AMOUNTS OF WATER FOR AT
LEAST 15 MINUTES. CONSULT PHYS FOR SPECIAL MEDICAL TREATMENT. SKIN:
WASH AF FECTED AREA W/SOAP & WATER. REMOVE CONTAMINATED CLOTHING.
CALL M.D.

Fire Fighting

Flash Point Method:SCC
Flash Point:103F,39C
Extinguishing Media:NFPA CLASSIFIES BURNING LIQ TO BE CLASS B. ANY
APPRVD CLASS B FIRE EXTING/EXTING AGENT MAY BE USED. CO2, DRY CHEM,
FOAM.
Fire Fighting Procedures:FULL PROT EQUIP INCL NIOSH/ MSHA APPRVD
SELF-CNTND BREATHING APPAR SHOULD BE USED. WATER SPRAY MAY BE
INEFFECTIVE. IF WATER IS USED, FOG NOZZLES (SEE SUPP DATA)
Unusual Fire/Explosion Hazard:COMBUST. KEEP CONTR TIGHTLY CLOSED.
ISOLATE FROM HEAT& FLAME. CLOSED CONTR MAY EXPLO WHEN EXPOS TO
EXTREM HEAT. APPLICATION TO HOT SURFACES (SEE SUPP DATA)

Accidental Release

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION (FLAME AND HOT
SURFACES). VENT AREA & AVOID BREATHING VAPORS. CONTAIN & REMOVE
W/INERT ABSORBENT MATERIAL USING NON-SPARKING TOOLS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:DON'T STOR IN SUN/ABOVE 120 F. OSHA
STOR CATEGORY: STORE LARGE QTIES IN BUILDINGS DESIGNED FOR
STOR/FLAMM/COMBUST LIQS.
Other Precautions:DON'T TAKE INTERNALLY. DON'T WELD/FLAME CUT W/OUT
PROPER VENT TO INSURE AREA IS FREE OF FLAMM VAPORS. DON'T CUT,
PUNCTURE/WELD ON/NEAR CONTR. ENTRANCE INTO CLOSED STOR TANKS: USE
APPROP NIOSH/MSHA APP RVD RESP/AIR LINE FOR (SEE SUPP DATA)

Exposure Controls

Respiratory Protection:APPROVED CHEMICAL MECHANICAL FILTER RESPIRATOR
DESIGNED TO REMOVE A COMBINATION OF PARTICULATE AND VAPORS.
(NIOSH/MSHA TC 23C OR EQUIVALENT).
Ventilation:ALL APPLICATION AREAS SHOULD BE VENT IN ACCORDANCE W/OSHA
REG 29 CFR 1910 DURING USE & UNTIL AREA IS FREE OF VAPORS.
Protective Gloves:IMPERVIOUS GLOVES REQUIRED DURING USE.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:USE PROT SKIN CREAM. EYE PROT: W/SPLASH
GUARDS FOR BRUSH/ROLLER APPLIC.
Work Hygienic Practices:WEAR CLEAN UNCONTAMINATED CLOTHING.
Supplemental Safety and Health
FIRE FIGHT PROC: ARE PREF. WATER MAY BE USED TO COOL CLOSED CONTRS TO
PREVENT PRESSURE BUILD-UP & POSS AUTO IGNIT/EXPLO WHEN EXPOS TO
EXTREME HEAT. EXPLO HAZ: REQ SPEC PREC. DURING EMERG CONDITIONS, O
VEREXPOS TO DECOMP PROD MAY CAUSE A HLTH HAZ. SYMP MAY NOT BE
IMMED. (SEE INGRED 8) (HNDLG/STOR PREC: SEE INGRED 8).

Chemical Properties

HCC:F4
Boiling Pt:B.P. Text:310F,154C
Vapor Density:HVR/AIR
Evaporation Rate & Reference:SLOWER THAN ETHYL ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, STRONG ACIDS OR BASES AND SELECTED AMINES.
Stability Condition to Avoid:HIGH TEMPERATURES AND FLAME.
Hazardous Decomposition Products:SMOKE, ACRID FUMES, CARBON MONOXIDE
AND/OR CARBON DIOXIDE.

Disposal

Waste Disposal Methods:DISPOSE IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.